Refilling Oil Tank - h/p/cosmos 150/50 Operating And Service Manual

running, cycling, cross-country, skating
Valve cock position [1] horizontally: the distributor [2] is adjusted for
lubrication [3] only in the centre of the running deck [4].
The valve cock position only influences the distribution of the oil amount
to the various oil outlets (tubes).
The total oil supply amount of the oil -pump always remains constant,
independent of the valve cock position.
The control lamp "Empty oil tank" on the external control unit indicates a
nearly empty oil tank. Refill the oil-tank when the control lamp
illuminates.
Valve cock position [1] vertically: the distributor [2] is adjusted for
lubrication [3] over the entire width of the running deck [4].
The valve cock position only influences the distribution of the amount of
oil to the various oil outlets (tubes). The total oil supply amount of the oil
pump always remains constant, independent of the valve cock position.
The control lamp "empty oil-tank" on the external control unit indicates
that the oil tank is nearly empty. Refill the oil-tank when the control lamp
illuminates.
At standard settings the word "OIL" will flash after 1000 km of operation. If this occurs, check the oil level in the oil
tank and refill preterm if necessary.
Because the device does not have a sensor, the oil message will not extinguish automatically. After checking the
oil level, the message has to be reset with "OP01".
8.4.5

Refilling oil tank

Unplug the device and wait for one minute.
N
The oil tank is located in the external control unit of the device below at the left. (For devices constructed
N
before 2002 and without external control unit, the oil-tank is located at the rear of the machine close to the
drive engine.)
Open the lid of the tank and refill the oil-tank with approximately 0.5 litres of the provided original oil, which
N
can be ordered at h/p/cosmos. For devices constructed before 2002 and without an external control unit, add
approximately 1 to 1.5 litres)
Close the lid of the oil-tank, plug in the power plug and switch the device on.
N
Check control lamp on the external control unit. If it is no longer illuminated, the oil-tank has been sufficiently
N
refilled.
If necessary, reset the oil message with „OP 01".
N
Special oil for sliding plate with automatic lubrication/0.25l bottle [cos14007]
Special oil for sliding plate with automatic lubrication/0.50l bottle [cos13438]
© 2013 h/p/cosmos sports & medical gmbh
[inline, roller ski]
wheelchair
file: n:\article\cos14310m5-v1_07hpc-en\20130207_cos14310m5-v1.07hpc-en_h-p-cosmos_treadmill_manual.doc
author: fh email@h-p-cosmos.com
maintenance and safety inspections
created 07.02.2013 printed 04.03.2013 page: 117 of 197