Table 2.1 Status And Meanings Of Each Led (Operation Panel (Controller Enclosure)) - Fujitsu Eternus DX60 S2 User Manual

Chapter 2 Components
2.1 Controller Enclosure
●
Part explanation
• Power switch
This switch is used to turn on or off the ETERNUS DX Disk storage system.
• AUTO POWER switch
Enables the AC Auto-Link Mode (This function automatically turns on the linked device once
AC power is supplied).
The AUTO POWER switch function is disabled for the factory default setting.
• MODE SELECT switch
Enables the device power to be turned on via power linkage.
The MODE SELECT switch is enabled for the factory default setting. Do not change to OFF.
• IP RESET switch
For dual controller type, click once to switch the Master CM LAN port from the current
controller to the other controller.
Click twice in succession within a two second interval to revert the LAN port settings of the
ETERNUS DX Disk storage system to their factory settings.
• LEDs
The states of LEDs are listed below.
Table 2.1
POWER
READY
FAULT
IDENTIFY
CACHE
FUJITSU Storage ETERNUS DX60 S2 Disk storage system User's Guide -Installation-
Status and meanings of each LED (operation panel (controller enclosure))
LED name LED status
(green)
(green)
(orange)
(blinks orange)
(blinks blue)
(green)
(blinks green)
Copyright 2014 FUJITSU LIMITED
ETERNUS DX Disk storage system status
DC power is supplied to the controller enclosure.
The ETERNUS DX Disk storage system is available
for use.
The ETERNUS DX Disk storage system is in error
status.
A part of the ETERNUS DX Disk storage system
requires preventive maintenance.
As ordered via ETERNUS Web GUI, the installation
location of the controller enclosure is identified.
There is data in the ETERNUS DX Disk storage
system cache memory.
Data in the cache memory is saved to a non-volatile
memory.
30
P3AM-5502-05ENZ0