Fujitsu Eternus DX60 S2 User Manual page 82

Chapter 5 Setup
5.1 Basic Setup
3
FUJITSU Storage ETERNUS DX60 S2 Disk storage system User's Guide -Installation-
Check that all enclosure's POWER LED and READY LED are lit up.
LED for drive enclosure
LED for controller enclosure
When checking the connection between the PC terminal and the ETERNUS DX Disk
storage system, execute the "ping" command at the command prompt of the PC terminal.
The following is an example of ping execution: ("192.168.1.1" is the default IP address)
ping 192.168.1.1
If the execution results in an error, check the network settings of the PC terminal.
If communication fails even though the MNT port of Controller 0
IMPORTANT
(CM#0) and the LAN port of the PC terminal are connected, check
that the Master LED of Controller 0 (CM#0) is on. If the Master LED
of Controller 1 (CM#1) is on for a dual-controller type, use the MNT
port of Controller 1 (CM#1).
Copyright 2014 FUJITSU LIMITED
Drive enclosure
Controller enclosure
82
End of procedure
P3AM-5502-05ENZ0