Powering On - Fujitsu Eternus DX60 S2 User Manual

Chapter 5 Setup
5.1 Basic Setup
5.1.2

Powering On

Turn on the PC terminal and the ETERNUS DX Disk storage system.
Follow the procedure below to turn on the ETERNUS DX Disk storage system.
IMPORTANT
Procedure
1
2
FUJITSU Storage ETERNUS DX60 S2 Disk storage system User's Guide -Installation-
Before turning on the ETERNUS DX Disk storage system, make sure that
the main line switches of the power distribution units and the PSU switches
on the power supply units of the ETERNUS DX Disk storage system are
"ON" and that the LINE LED of the drive enclosure is green.
• After turning the power on, it takes about three minutes for the
ETERNUS DX Disk storage system to become READY (i.e. the READY
LED turns on). If an error is detected during the initial power-on
diagnostic phase, a longer time (up to ten minutes) may be required
before the READY LED turns on.
• When turning on the ETERNUS DX Disk storage system for the first
time, volume formatting operation, which is set as factory default, may
be performed. However, the ETERNUS DX Disk storage system setting
operation can be continued. When canceling a volume format, delete
the volume. For details on how to delete volume, refer to "ETERNUS
Web GUI User's Guide".
Press the power switch ( ) of the controller enclosure.
Controller enclosure POWER LED turns on.
When a drive enclosure is installed, the power turns on
automatically.
Power switch
After about three minutes, check that the READY LED on the controller
enclosure are lit up.
Copyright 2014 FUJITSU LIMITED
Drive Enclosure
Controller Enclosure
81
P3AM-5502-05ENZ0