Components (Front); Figure 1.5 Operation Panel (Controller Enclosure); Table 1.1 Status And Meanings Of Each Led (Operation Panel (Controller Enclosure)) - Fujitsu ETERNUS DX600 S3 Basic Operation Manual

Chapter 1 Component Name/LED Name
1.1 Controller Enclosures
1.1.3

Components (Front)

This section describes the operation panel, PCIe Flash Module (PFM), and the batteries in the front of the
controller enclosure.
■
Operation Panel
An operation panel has LEDs and a Power switch.
Figure 1.5 shows the operation panel.

Figure 1.5 Operation Panel (Controller Enclosure)

1. Power switch
This switch is used to turn on or off the ETERNUS DX.
2. POWER LED
3. IDENTIFY LED
4. FAULT LED
5. MAINTENANCE LED
6. CACHE LED
7. READY LED
8. REMOTE LED
The LEDs turn on or blink to indicate the statuses that are listed below.

Table 1.1 Status and Meanings of Each LED (Operation Panel (Controller Enclosure))

LED name
POWER
IDENTIFY
FAULT
FUJITSU Storage ETERNUS DX500 S3/DX600 S3 Disk storage system Operation Guide (Basic)
Table 1.1
1
2
3 4
5 6
7 8
LED status
(green)
(blinks blue)
(amber) (*1)
(blinks amber)
Copyright 2014 FUJITSU LIMITED
shows the status and meanings of each LED.
Meanings
Power is supplied to the controller enclosure.
The installation location of the controller is identified according
to the instruction that is issued from ETERNUS Web GUI or ETER-
NUS CLI.
The ETERNUS DX is in error status.
A part of the ETERNUS DX requires preventive maintenance.
15
P3AM-7742-04ENZ0