Fujitsu Eternus DX60 S2 User Manual page 71

Chapter 4 Connecting Cables
4.3 Drive Enclosure Connection
1-2
2
■ For single controller type
FUJITSU Storage ETERNUS DX60 S2 Disk storage system User's Guide -Installation-
Connect the plug to be connected to DI (IN) port, to the DI (IN) port of the expander 0
(EXP#0).
Drive Enclosure
For dual controller type, connect the SAS (OUT) port at controller 1 (CM#1) of
controller enclosure, to the SAS (IN) port at expander 1 (EXP#1) of the drive
enclosure 1 with the miniSAS cable.
Connect the miniSAS cable in the same way as
The following figure shows a miniSAS connection between a controller enclosure and a
drive enclosure.
Do not connect anything to the SAS (OUT) port on the end edge.
IMPORTANT
Drive
Enclosure
Controller
Enclosure
Copyright 2014 FUJITSU LIMITED
Step
EXP#0
CM#0
71
1.
P3AM-5502-05ENZ0