Component Names And Led Names; Figure 30 Operation Panel (Eternus Dx60 S5/Dx100 S5/Dx200 S5); Table 14 Status And Meaning Of Each Led (Operation Panel [Controller Enclosure For The Eternus Dx60 S5/Dx100 S5/Dx200 S5]) - Fujitsu ETERNUS DX S5 Series Operation Manual (Basic

A. Component Names
Controller Enclosure

Component Names and LED Names

This section describes the operation panel, the drives, the controllers, the power supply units, the host
interfaces, the PCIe Flash Modules (PFMs), the batteries, and the BUDs of the controller enclosure.
■
Operation Panel
●
ETERNUS DX60 S5/DX100 S5/DX200 S5
An operation panel has LEDs, a Power switch, and a FUNCTION button.
Figure 30
1
IDENTIFY LED
MAINTENANCE LED
READY LED
1
Power switch
This switch is used to turn on or off the ETERNUS DX.
2
FUNCTION button
This button is used to switch the maintenance status on or off, to switch the master CM (when two
controllers are mounted), to initialize the LAN ports, or to initialize the user settings.
The LEDs turn on or blink to indicate the statuses that are listed below.
Table 14 Status and Meaning of Each LED (Operation Panel [Controller Enclosure for the ETERNUS DX60
S5/DX100 S5/DX200 S5])
LED name
POWER
IDENTIFY
FAULT
MAINTENANCE
Operation Panel (ETERNUS DX60 S5/DX100 S5/DX200 S5)
With a flange cover
POWER LED
FAULT LED
CACHE LED
LED status
(green)
(blinks blue)
(amber) (*1)
(blinks amber)
(green)
(blinks green)
Without a flange cover
1
IDENTIFY LED
MAINTENANCE LED
READY LED
Meaning
DC power is supplied to the controller enclosure.
The installation location of the controller enclosure is identified
according to the instruction that is issued from ETERNUS Web GUI or
ETERNUS CLI.
The ETERNUS DX is in error status.
A part of the ETERNUS DX requires preventive maintenance.
Maintenance for the ETERNUS DX is in progress.
Maintenance (from ETERNUS Web GUI or ETERNUS CLI) for the
ETERNUS DX is in progress or a status check of the ETERNUS DX is
necessary.
105
POWER LED
FAULT LED
CACHE LED
2
Operation Guide (Basic)