Components (Front); Figure 1.5 Operation Panel (Controller Enclosure); Table 1.1 Status And Meanings Of Each Led (Operation Panel (Controller Enclosure)) - Fujitsu ETERNUS DX100 S4 Basic Operation Manual

Chapter 1 Component Names and LED Names
1.1 Controller Enclosures
1.1.3

Components (Front)

This section describes the operation panel and the drives in the front of the controller enclosure.
■
Operation Panel
An operation panel has LEDs, a Power switch, and a FUNCTION button.
Figure 1.5 shows the operation panel.

Figure 1.5 Operation Panel (Controller Enclosure)

A
1
3
5
7
A. With a flange cover
B. Without a flange cover
1. Power switch
This switch is used to turn on or off the ETERNUS DX.
2. POWER LED
3. IDENTIFY LED
4. FAULT LED
5. MAINTENANCE LED
6. CACHE LED
7. READY LED
8. FUNCTION button
This button is used to switch the maintenance status, to switch the master CM (when two controllers are
mounted), to initialize the LAN ports, or to initialize the user settings.
The LEDs turn on or blink to indicate the statuses that are listed below.

Table 1.1 Status and Meanings of Each LED (Operation Panel (Controller Enclosure))

LED name
POWER
IDENTIFY
FUJITSU Storage ETERNUS DX100 S4/DX200 S4, ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems Operation Guide (Basic)
Table 1.1
1
2
3
4
6 5
7
LED status
(green)
(blinks blue)
17
Copyright 2017 FUJITSU LIMITED
shows the status and meanings of each LED.
B
2
4
6
8
Meaning
DC power is supplied to the controller enclosure.
The installation location of the controller enclosure is identified
according to the instruction that is issued from ETERNUS Web GUI
or ETERNUS CLI.
P3AM-7662-09ENZ0