Fujitsu Eternus DX60 S2 User Manual page 52

Chapter 3 Rack Installation
3.2 Installing Controller Enclosure
■ For regions other than EMEA&I
FUJITSU Storage ETERNUS DX60 S2 Disk storage system User's Guide -Installation-
(1)
Adjust the sizes of the rack rail (for left side) and the rack rail (for right side) to fit the
rack.
Loosen the M4 screws to adjust the length of the rack rails to match the distance
between the front and rear rack pillars. Leave the M4 screws slightly unscrewed, as the
rack rails must be attached to the rack before they can be completely tightened.
Bracket L (for left side)
"L" is stamped on the inner
side of the left rack rail.
[Left]
(Front rack pillars)
(2)
Attach the rack rails to the rack.
•
•
Screw holders
M5 screws
(Front rack pillars)
M5 screws
Copyright 2014 FUJITSU LIMITED
(Rear rack pillars)
Loosen the M4 screws,
and adjust the rack rails to
the depth of the rack.
Bracket R (for right side)
"R" is stamped on the inner
side of the right rack rail.
[Right]
If the rack pillars have square (approx. 9mm) holes, screw
holders will need to be used when attaching the rack rails
(brackets).
Make sure to attach the rack rails and rack pillars so that they
fit exactly together without any space between them.
Bracket L
Bracket R
Screw holders
52
Screw holders
M5 screws
M5 screws
(Rear rack pillars)
Screw holders
P3AM-5502-05ENZ0