Figure 1.5 Connection Example Without A Dedicated Remote Support Port - Fujitsu Eternus DX60 S2 User Manual

Chapter 1 Preparation
1.1 Connection Preparation
• Network devices and cables
Network devices, such as LAN switches, must be prepared to connect an ETERNUS DX Disk
storage system to the LAN. When the LAN for remote support is separate from the LAN for
operation management, routers and LAN cables must be prepared to connect to the other
network.
●
Connection example without a dedicated remote support port
The MNT ports are used for the network connection of the remote support. The RMT ports are
not used.
-
-
-
-
Figure 1.5
FUJITSU Storage ETERNUS DX60 S2 Disk storage system User's Guide -Installation-
For the ETERNUS DX Disk storage system, one IP address for the MNT port is required.
An IP address is required for a PC terminal that is used for maintenance operations
performed by a maintenance engineer.
Network devices such as LAN switches are required for operation management.
Two enhanced Cat-5 twisted-pair type LAN cables are required to connect the ETERNUS
DX Disk storage system to the LAN for operation management.
SNMP
Administration
terminal manager
LAN switch
PC terminal used for maintenance
IP:x.x.x.a
CM#0
Controller enclosure
ETERNUS DX Disk storage system
Connection example without a dedicated remote support port
Copyright 2014 FUJITSU LIMITED
NTP server
Mail server
LAN for operation management
IP:x.x.x.d
This PC terminal is used for maintenance operations.
RMT ports are not used.
CM#1
: Enhanced Cat-5 twisted-pair type LAN cables
19
Remote support
center
P3AM-5502-05ENZ0