Fujitsu Eternus DX60 S2 User Manual page 63

Chapter 4 Connecting Cables
4.1 LAN Cable Connection (For Operation Management)
Procedure
1
2
3
3-1
FUJITSU Storage ETERNUS DX60 S2 Disk storage system User's Guide -Installation-
Connect the LAN cable to the ETERNUS DX Disk storage system.
Connect the LAN cable connectors to the MNT ports of the controller 0 (CM#0) and
controller 1 (CM#1) for the ETERNUS DX Disk storage system.
CAUTION
•
Connect the LAN cables to the networking equipment.
Connect the other end of the LAN cable to the networking equipment, such as LAN switch
or router. For networking equipment connection details, refer to the documentation for the
networking equipment being connected to.
If the RMT ports are to be used, connect the LAN cables to RMT ports. (This
step is applicable to regions other than EMEA&I.)
Connect the connector of the LAN cable to the RMT port of the controller 0 (CM#0) and
controller 1 (CM#1).
Copyright 2014 FUJITSU LIMITED
Do
When connecting the LAN cables, position them so that they
will not obstruct replacement of the power supply unit or
controllers by the maintenance engineer.
63
P3AM-5502-05ENZ0