Figure 1.7 Connection Example When The Ip Address Of The Slave Cm Is Set (And A Dedicated Remote Support Port Is Not Used) - Fujitsu Eternus DX60 S2 User Manual

Chapter 1 Preparation
1.1 Connection Preparation
FUJITSU Storage ETERNUS DX60 S2 Disk storage system User's Guide -Installation-
The following section provides connection examples and explains the
necessary preparation for when the IP address of the Slave CM is set.
• Connection example without a dedicated remote support port
- For the ETERNUS DX Disk storage system, two IP addresses for the
MNT port are required.
- An IP address is required for a PC terminal that is used for
maintenance operations performed by a maintenance engineer.
- Network devices such as LAN switches are required for operation
management.
- Two enhanced Cat-5 twisted-pair type LAN cables are required to
connect the ETERNUS DX Disk storage system to the LAN for
operation management.
SNMP
Administration
manager
terminal
LAN switch
PC terminal used for maintenance
IP:x.x.x.a
CM#0
Controller enclosure
ETERNUS DX Disk storage system
Figure 1.7 Connection example when the IP address of the Slave CM
is set (and a dedicated remote support port is not used)
21
Copyright 2014 FUJITSU LIMITED
Mail server NTP server
LAN for operation management
IP:x.x.x.d
This PC terminal is used for maintenance operations.
IP:x.x.x.b
RMT ports are not used.
IP addresses for both the Master CM
and Slave CM are set.
CM#1
: Enhanced Cat-5 twisted-pair type LAN cables
Remote support
center
P3AM-5502-05ENZ0