Figure 1.4 Drives; Table 1.1 Status And Meanings Of Each Led (Operation Panel) - Fujitsu ETERNUS DX200F Operation Manual

Chapter 1 Component Name/LED Name
1.3 Components (Front)
1. Power switch
This switch is used to turn on or off the ETERNUS DX.
2. POWER LED
3. IDENTIFY LED
4. FAULT LED
5. MAINTENANCE LED
6. CACHE LED
7. READY LED
8. FUNCTION button
This button is used to switch the maintenance status, to switch the master CM, or to initialize the LAN ports.
The states of LEDs are listed below.

Table 1.1 Status and Meanings of Each LED (Operation Panel)

LED name
POWER
IDENTIFY
FAULT
MAINTENANCE
CACHE
READY
■
Drives
Figure 1.4 shows the drive.
Table 1.2 shows the status and meanings of each LED.

Figure 1.4 Drives

1 2
1. DRIVE READY LED
LED status
(green)
(blinks blue)
(amber)
(blinks amber)
(green)
(blinks green)
(green)
(green)
Figure 1.5 shows the slot number of each drive.
14
FUJITSU Storage ETERNUS DX200F All Flash Array Operation Guide (Basic)
Copyright 2014 FUJITSU LIMITED
Meaning
DC power is supplied to the ETERNUS DX.
The installation location of the ETERNUS DX is identified accord-
ing to the instruction that is issued from ETERNUS Web GUI or
ETERNUS CLI.
The ETERNUS DX is in error status.
A part of the ETERNUS DX requires preventive maintenance.
Maintenance for the ETERNUS DX is in progress.
Maintenance or a status check via ETERNUS Web GUI or ETERNUS
CLI is necessary.
There is data in the cache memory of the ETERNUS DX.
The ETERNUS DX is available for use.
P3AM-8472-01ENZ0