Fujitsu Eternus DX60 S2 User Manual page 59

Chapter 3 Rack Installation
3.3 Installing Drive Enclosure
2
FUJITSU Storage ETERNUS DX60 S2 Disk storage system User's Guide -Installation-
(2)
Attach the rack rails (brackets) to the rack.
•
•
Screw holders
M5 screws
(Front rack pillars)
M5 screws
The M5 screw positions for the rack rails are determined relative to the drive enclosure
base line.
Insert the M5 screws in the 1st and 3rd holes on the front and rear rack pillars above
the base lines to fasten the rack rails.
[Left]
3rd position
2U
(M5 screws)
1st position
(M5 screws)
Base line of
drive enclosure
(3)
Tighten the M4 screws of the rack rails that were slightly unscrewed in
Install the drive enclosure in the rack.
CAUTION
•
Copyright 2014 FUJITSU LIMITED
If the rack pillars have square (approx. 9mm) holes, screw
holders will need to be used when attaching the rack rails
(brackets).
Make sure to attach the rack rails and rack pillars so that they
fit exactly together without any space between them.
Bracket L
Bracket R
Screw holders
[Right]
3rd position
Drive enclosure
(M5 screws)
1st position
(M5 screws)
Rack rails
(Brackets)
Do
When installing or removing the drive enclosure to or from the
rack, make sure to have the right and left sides and the bottom
of the drive enclosure by two or more people. Failure to do so
may cause injury.
59
Screw holders
M5 screws
M5 screws
(Rear rack pillars)
Screw holders
Step
P3AM-5502-05ENZ0
(2).