Figure 2.24 Power Supply Units; Table 2.10 Status And Meanings Of Each Led (Expander); Table 2.11 Status And Meanings Of Each Led (Power Supply Unit) - Fujitsu Eternus DX60 S2 User Manual

Disk storage system
Hide thumbs Also See for Eternus DX60 S2:
Table of Contents

Advertisement

Chapter 2 Components
2.2 Drive Enclosure
Table 2.10
IDENTIFY
DI (IN) LINKUP
LED
UNIT READY/
FAULT
Power Supply Units
The power supply unit transforms input AC power from a power socket to DC power and supplies
power to each component.
Each power supply unit contains a fan.

Figure 2.24 Power supply units

Part explanation
Inlet
This inlet is used to connect a power cord.
LEDs
The states of LEDs are listed below.
Table 2.11
STATUS
FUJITSU Storage ETERNUS DX60 S2 Disk storage system User's Guide -Installation-
Status and meanings of each LED (expander)
LED name
LED status
(blinks blue)
(off)
(green)
(orange)
(green)
(orange)
STATUS LED
Status and meanings of each LED (power supply unit)
LED name
LED status
(green)
(blinks green)
(orange)
Copyright 2014 FUJITSU LIMITED
As ordered via ETERNUS Web GUI, the installation
location of the drive enclosure is identified.
The link between the DI (IN) port and the destination
has been established.
The DI (IN) port is in error status.
The expander is in normal status.
The controller is performing the initial setup after
the power is turned on.
The expander is in error status.
Inlet
Power supply unit status
AC power is supplied to the power supply unit and the
ETERNUS DX Disk storage system (DC power) is
turned on.
AC power is supplied to the power supply unit but the
ETERNUS DX Disk storage system (DC power) is not
turned on.
The power supply unit or the fan in the power supply
unit is in error status.
42
Expander status
P3AM-5502-05ENZ0

Advertisement

Table of Contents
loading

Table of Contents