Power Synchronized Unit Connection; Power Cord Connection; When No Power Distribution Units Are Installed - Fujitsu Eternus DX60 S2 User Manual

Chapter 4 Connecting Cables

4.4 Power Synchronized Unit Connection

■ For dual controller type
4.4 Power Synchronized Unit Connection
When using a power synchronized unit for power control, connect the power synchronized unit to
the ETERNUS DX Disk storage system.
Refer to "User's Guide -Power Synchronized Unit-" that is provided with the power synchronized
unit for details about power synchronized units, the procedure for connecting power synchro-
nized units to the ETERNUS DX Disk storage system, and required settings.
4.5

Power Cord Connection

Connect the power cords to the ETERNUS DX Disk storage system.
4.5.1

When no Power Distribution Units are Installed

The following explains how to connect the power cords when power distribution unit for ETER-
NUS DX Disk storage system is not installed.
Two power cords (4m) are provided for each enclosure.
IMPORTANT
FUJITSU Storage ETERNUS DX60 S2 Disk storage system User's Guide -Installation-
Drive
Enclosure
Controller
Enclosure
To help with power cord management and prevent incorrect connections,
attach labels to the power cords and make a note of connection origins and
destinations.
Copyright 2014 FUJITSU LIMITED
EXP#0
CM#0 CM#1
72
EXP#1
End of procedure
P3AM-5502-05ENZ0