Installing Power Distribution Unit (2U) - Fujitsu Eternus DX60 S2 User Manual

Chapter 3 Rack Installation
3.1 Installing Power Distribution Unit (For Regions other than EMEA&I)
4
3.1.2

Installing Power Distribution Unit (2U)

This section describes how to install the Power distribution unit for ETERNUS DX Disk storage
system (2U, Max 8 enclosures execution) in a rack.
Procedure
1
FUJITSU Storage ETERNUS DX60 S2 Disk storage system User's Guide -Installation-
Attach the blank panel to the front side of the rack.
The blank panel should be attached at the same height as the power distribution unit.
Power distribution unit
(Rear rack pillars)
This section explains the connection procedure for power distribution units
(2U, Max 6 enclosures connection). This procedure can also be applied for
Power distribution unit (2U, Max 8 enclosures connection).
Attach the M5 cage nuts to the rear rack pillar.
• Attachment positions
On either side, insert eight M5 cage nuts in the 1st, 3rd, 4th, and 6th holes above the
power distribution unit base line.
(Rear rack pillars)
M5 cage nut
[Left]
6th position
4th position
2U 1U
1U
3rd position
1st position
Copyright 2014 FUJITSU LIMITED
Blank panel
(Front rack pillars)
M5 cage nut
[Right]
6th position
4th position
Power distribution unit
Power distribution unit
3rd position
1st position
Base line of
power distribution unit
48
End of procedure
P3AM-5502-05ENZ0