Figure 2.13 Controller (Iscsi Model); Table 2.4 Status And Meanings Of Each Led (Fc Model Controller) - Fujitsu Eternus DX60 S2 User Manual

Chapter 2 Components
2.1 Controller Enclosure
Table 2.4
SCU STATUS
IDENTIFY
DI (OUT) LINKUP
FC LINKUP/
FAULT
UNIT READY/
FAULT
MASTER
ACT
LINK
■
iSCSI model

Figure 2.13 Controller (iSCSI model)

FUJITSU Storage ETERNUS DX60 S2 Disk storage system User's Guide -Installation-
Status and meanings of each LED (FC model controller)
LED name LED status
(green)
(blinks green)
(blinks blue)
(off)
(green)
(green)
(orange)
(green)
(orange)
(green)
(green)
(green)
SCU STATUS LED
IDENTIFY LED
DI (OUT) LINKUP LED
LAN (RMT) port
LAN (MNT) port
ACT LED
LINK LED
DI (OUT) port
Copyright 2014 FUJITSU LIMITED
The SCU is in normal status.
SCU is charging.
As ordered via ETERNUS Web GUI, the installation
location of the controller enclosure is identified.
The link between the DI (OUT) port and the
destination has been established.
The link between the FC port (host interface port) and
the destination has been established.
The FC port (host interface port) is in error status.
The controller is in normal status.
•
The controller is performing the initial setup after
the power is turned on.
•
The controller is in error status.
The controller is set as a Master CM.
The controller is sending or receiving data via the LAN
port (for operation management).
The link between the LAN port (for operation
management) and the destination has been
established.
iSCSI port (0 (Left), 1 (Right))
UNIT READY/FAULT LED
MASTER LED
PWC port
FAULT LED
LINK LED
34
Controller status
P3AM-5502-05ENZ0