Fujitsu Eternus DX60 S2 User Manual page 49

Chapter 3 Rack Installation
3.1 Installing Power Distribution Unit (For Regions other than EMEA&I)
2
3
FUJITSU Storage ETERNUS DX60 S2 Disk storage system User's Guide -Installation-
• Attachment procedure
Clip the M5 cage nut tabs into the desired hole from the inside.
Side view
M5 cage nut
Rack pillar (square)
Install the power distribution unit in the rack.
Fasten it to the prepared holes in the pillars with eight M5 screws.
M5 screws
M5 screws
Attach the blank panel to the rack front.
The blank panel should be attached at the same height as the power distribution unit.
Power distribution unit
(Rear rack pillars)
Copyright 2014 FUJITSU LIMITED
(Rear rack pillars)
Blank panel
(Front rack pillars)
49
End of procedure
P3AM-5502-05ENZ0