Table 2.1 Status And Meanings Of Each Led (Operation Panel (Controller Enclosure)) - Fujitsu ETERNUS DX80 S2 User's Manual & Installation Instructions

Chapter 2 Components
2.1 Controller Enclosure
●
Part explanation
• Power switch
This switch is used to turn on or off the ETERNUS DX Disk storage system.
• FUNCTION button
Hold down the button for three seconds during maintenance to stop the maintenance operation. Hold
down the button for three seconds while a maintenance operation is not performed to start the
maintenance operation.
For a dual-controller type, press the button twice within three seconds during maintenance to switch the
Master CM to the other controller.
Press the button three times within three seconds during maintenance to restore the factory default
settings of the LAN ports.
• LEDs
The states of LEDs are listed below.
Table 2.1
LED name
POWER
READY
FAULT
MAINT/ID
CACHE
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Installation-
Status and meanings of each LED (operation panel (controller enclosure))
LED status
(green)
(green)
(amber)
(blinks amber)
(green)
(blinks green)
(green)
Copyright 2013 FUJITSU LIMITED
ETERNUS DX Disk storage system status
DC power is supplied to the controller enclosure.
The ETERNUS DX Disk storage system is available for use.
The ETERNUS DX Disk storage system is in error status.
A part of the ETERNUS DX Disk storage system requires preventive
maintenance.
Maintenance for the ETERNUS DX Disk storage system is in progress.
•
As ordered via ETERNUS Web GUI or ETERNUS CLI, the
installation location of the controller enclosure is identified.
•
Maintenance or a status check via ETERNUS Web GUI or
ETERNUS CLI is necessary.
There is data in the ETERNUS DX Disk storage system cache memory.
30
P3AM-4832-07ENZ0