Chapter 2 Components
2.2 Drive Enclosure
Table 2.9
DISK READY/
FAULT
2.2.4
Components (Rear)
This section describes the expanders and the power supply units in the rear of the drive
enclosure.
■
Expander
The expander is a component that controls how the controller and the disks interact.
Figure 2.23 Expander
●
Part explanation
•
DI (IN) port
These ports are connectors for miniSAS cables.
•
LEDs
The states of LEDs are listed below.
FUJITSU Storage ETERNUS DX60 S2 Disk storage system User's Guide -Installation-
Status and meanings of each LED (3.5" disks)
LED name
LED status
(green)
(blinks green)
(orange)
IDENTIFY LED
DI (IN) LINKUP LED
These ports are not used.
Copyright 2014 FUJITSU LIMITED
The disk is operating normally.
The disk is in error status.
UNIT READY/FAULT LED
DI (IN) port
41
Disk status
P3AM-5502-05ENZ0