Component Names And Led Names; Figure 13 Operation Panel (Eternus Af150 S3/Af250 S3); Table 9 Status And Meaning Of Each Led (Operation Panel [Controller Enclosure For The Eternus Af150 S3/Af250 S3]) - Fujitsu ETERNUS AF S3 Series Basic Operation Manual

A. Component Names
Controller Enclosure

Component Names and LED Names

This section describes the operation panel, the drives, the controllers, the power supply units, the host
interfaces, the batteries, and the BUDs of the controller enclosure.
■
Operation Panel
●
ETERNUS AF150 S3/AF250 S3
An operation panel has LEDs, a Power switch, and a FUNCTION button.
Figure 13
1
IDENTIFY LED
MAINTENANCE LED
READY LED
1
Power switch
This switch is used to turn on or off the ETERNUS AF.
2
FUNCTION button
This button is used to switch the maintenance status on or off, to switch the master CM, to initialize
the LAN ports, or to initialize the user settings.
The LEDs turn on or blink to indicate the statuses that are listed below.
Table 9 Status and Meaning of Each LED (Operation Panel [Controller Enclosure for the ETERNUS AF150
S3/AF250 S3])
LED name
POWER
IDENTIFY
FAULT
MAINTENANCE
Operation Panel (ETERNUS AF150 S3/AF250 S3)
With a flange cover
POWER LED
FAULT LED
CACHE LED
LED status
(green)
(blinks blue)
(amber)
(blinks amber)
(green)
(blinks green)
Without a flange cover
1
IDENTIFY LED
MAINTENANCE LED
READY LED
Meaning
DC power is supplied to the ETERNUS AF.
The installation location of the ETERNUS AF is identified according to
the instruction that is issued from ETERNUS Web GUI or ETERNUS CLI.
The ETERNUS AF is in error status.
A part of the ETERNUS AF requires preventive maintenance.
Maintenance for the ETERNUS AF is in progress.
Maintenance (from ETERNUS Web GUI or ETERNUS CLI) for the
ETERNUS AF is in progress or a status check of the ETERNUS AF is
necessary.
71
POWER LED
FAULT LED
CACHE LED
2
Operation Guide (Basic)