When 1U Power Distribution Unit Is Installed (For Regions Other Than Emea&I) - Fujitsu Eternus DX60 S2 User Manual

Chapter 4 Connecting Cables
4.5 Power Cord Connection
2
4.5.2 When 1U Power Distribution Unit is Installed (For Regions other than
EMEA&I)
The following explains how to connect the power cord when a 1U power distribution unit is
installed.
IMPORTANT
Procedure
1
FUJITSU Storage ETERNUS DX60 S2 Disk storage system User's Guide -Installation-
Connect the power cords to the socket.
Connect the plug at the other end of each power cord to the socket.
• Power supply failure can be prevented by connecting the power
IMPORTANT
cords on the PSU#0 side and the PSU#1 side to different power
sources.
• After unplugging the power cord, wait until the POWER STATUS
LED of the power supply unit has turned off completely before
reconnecting it. (It takes about ten seconds for the STATUS LED
to be turned off completely.)
CAUTION
•
To help with power cord management and prevent incorrect connections,
attach labels to the power cords and make a note of connection origins and
destinations.
Remove the power cord clamp from the power distribution unit.
Power distribution unit
Copyright 2014 FUJITSU LIMITED
Do Not
Do not use the server service outlet to connect a power cord
for the ETERNUS DX Disk storage system.
Power cord clamps
74
End of procedure
P3AM-5502-05ENZ0