Chapter 4 Connecting Cables; Lan Cable Connection (For Operation Management) - Fujitsu Eternus DX60 S2 User Manual

Chapter 4
This chapter explains how to connect various cables to the ETERNUS DX Disk storage system.
4.1

LAN Cable Connection (For Operation Management)

This ETERNUS DX Disk storage system must be connected to a LAN to perform settings or
maintenance operations via ETERNUS Web GUI or ETERNUS CLI, to monitor the device status,
or when operating with remote support.
LAN cables (enhanced Cat-5 type) must be obtained separately.
The following explains how to connect the LAN cable.
IMPORTANT
FUJITSU Storage ETERNUS DX60 S2 Disk storage system User's Guide -Installation-
Connecting Cables
Do
CAUTION
• When performing the installation, make sure to wear a wrist strap or
touch a metal part to discharge the human body's natural static
electricity. Failure to discharge static electricity may cause device
failure.
• To help with LAN cable management and prevent incorrect connections,
attach labels to the LAN cables and make a note of connection origins
and destinations.
• When connecting LAN cables, check the connector orientation and then
firmly push it all the way in.
When disconnecting LAN cables, depress the tab, then pull out the
connector.
This section describes dual controller type as an example. Note that there
is only controller 0 (CM#0) for single controller type.
Copyright 2014 FUJITSU LIMITED
62
P3AM-5502-05ENZ0