Drive Enclosure Connection - Fujitsu Eternus DX60 S2 User Manual

Chapter 4 Connecting Cables

4.3 Drive Enclosure Connection

2
4.3 Drive Enclosure Connection
Only one drive enclosure can be connected to a 3.5" type controller enclosure.
Connect the controller enclosure to the drive enclosure with the miniSAS cable.
Two miniSAS cables (75cm) are supplied with each drive enclosure dual expander model, and
one miniSAS cable (75cm) with each drive enclosure single expander model.
The following explains how to connect the miniSAS cable.
IMPORTANT
FUJITSU Storage ETERNUS DX60 S2 Disk storage system User's Guide -Installation-
CAUTION
•
Connect the miniSAS cables to the server.
Connect the other end of the miniSAS cables to the server's SAS cards.
• To help with miniSAS cable management and prevent incorrect
connections, attach labels to the miniSAS cables and make a note of
connection origins and destinations.
• When connecting miniSAS cables, always check the symbols on the
connector.
- DI (OUT) of controller enclosure: Attach the connector with the
symbol to the port.
DI (OUT) port
- DI (IN) of drive enclosure: Attach the connector with the
the port.
DI (IN) port
Copyright 2014 FUJITSU LIMITED
Do
When connecting the miniSAS cables, position them so that
they will not obstruct replacement of the power supply unit or
controllers by the maintenance engineer.
Connector for connecting DI (OUT) port
Connector for connecting DI (IN) port
69
End of procedure
symbol to
P3AM-5502-05ENZ0