Konica Minolta bizhub C650 Service Manual page 229

6. Other
NOTE
• After replacing the service EEPROM board, be sure to make the above listed
adjustments before the first warm-up is made.
5. Turn OFF the main power switch and sub power switch.
6. Close the upper front door and turn ON the main power switch and sub power switch.
Check to see that warm-up and image stabilization operations are completed normally.
7. Enter the Service mode again. Make individual adjustments shown in the following
table in the order listed, using the machine management list and the adjustment lists
that were output at the time of main body installation and maintenance.
Order
1 Machine
2
3 Finisher
4 Machine
5
Imaging Process
Adjustment
6
7 Machine
8 Imaging Process
Adjustment
9 Machine
10 Imaging Process
Adjustment
11 System 1
12 Finisher
13 Machine
14 In this step, pull out the tray 3 and 4 and slide them in again.
15 Machine
16
17
18 Imaging Process
Adjustment
19
20
176
Items that require readjustment in the Service mode
LD adjustment
Manual Bypass Tray Adjustment
FS-FN adjustment
Printer Resist Loop
Thick Paper Density Adjustment
Monochrome Density Adjustment
Fusing Temperature
Transfer Belt
Thick Paper Mode
Transfer Belt
Charging CH cleaning
CB-FN adjustment
Printer Area
Fusing Transport Speed
Color alignment Adjustment
Printer Area
Transfer Output Fine
Adjustment
Paper separation adjustment
Field Service Ver. 8.0 Jun. 2008
LD lightness balance adjust.
Auto Cleaning
Cleaning Bias
Cleaning
Paper Feed Direction Adj.
Centering
Centering (Duplex 2nd Side)
Leading Edge Adjustment
Leading Edge Adj.
(Duplex Side 2)
Secondary transfer adj.
Primary transfer adj.
Ref. page
P.458
P.460
P.540
P.456
P.466
P.467
P.444
P.462
P.460
P.462
P.491
P.540
P.451
P.445
P.443
P.448
P.450
P.447
P.449
P.465
P.465
P.467