Table of Contents
Advertisement
TCP / IP Settings
Configuring the wireless bridge with an IP address expands your ability to manage
the wireless bridge. A number of wireless bridge features depend on IP addressing
to operate.
You can use the web browser interface to access IP addressing only if the
Note:
wireless bridge already has an IP address that is reachable through your
network.
By default, the wireless bridge will be automatically configured with IP settings from
a Dynamic Host Configuration Protocol (DHCP) server. However, if you are not
using a DHCP server to configure IP addressing, use the CLI to manually configure
the initial IP values (page 5-2). After you have network access to the wireless bridge,
you can use the web browser interface to modify the initial IP configuration, if
needed.
If there is no DHCP server on your network, or DHCP fails, the wireless
Note:
bridge will automatically start up with a default IP address of 192.168.1.1.
DHCP Client (Enable) – Select this option to obtain the IP settings for the wireless
bridge from a DHCP (Dynamic Host Configuration Protocol) server. The IP address,
subnet mask, default gateway, and Domain Name Server (DNS) address are
dynamically assigned to the wireless bridge by the network DHCP server.
(Default: Enabled)
Advanced Configuration
6
6-5
Advertisement
Table of Contents
