Table of Contents
Advertisement
• If AES is enabled, each wireless bridge link in the network must be
configured to use the same AES key
• The AES key type value entered using the key command must be the same
as the type specified in the encryption command.
Example
DUAL OUTDOOR(if-wireless a)#key wep 1 64 ascii 12345
DUAL OUTDOOR(if-wireless a)#key wep 2 64 ascii abcde
DUAL OUTDOOR(if-wireless a)#
Related Commands
encryption (7-77)
transmit-key
This command sets the index of the WEP key to be used for encrypting data frames
broadcast or multicast from the wireless bridge.
Syntax
transmit-key <index>
index - Key index. (Range: 1-4)
Default Setting
1
Command Mode
Interface Configuration (Wireless)
Command Usage
• If you use WEP key encryption, the wireless bridge uses the transmit key to
encrypt multicast and broadcast data signals that it sends to other nodes.
Other keys can be used for decryption of data from other nodes.
Example
DUAL OUTDOOR(if-wireless a)#transmit-key 2
DUAL OUTDOOR(if-wireless a)#
Wireless Interface Commands
7
7-79
Advertisement
Table of Contents
