Show Authentication; Wds Commands - Hirschmann BAT54 Installation Manual

7
Command Line Interface
Command Mode
Global Configuration
Example
DUAL OUTDOOR(config)#mac-authentication session-timeout 1
DUAL OUTDOOR(config)#

show authentication

This command shows all 802.1x authentication settings, as well as the address filter
table.
Command Mode
Exec
Example
DUAL OUTDOOR#show authentication
Authentication Information
=========================================================
MAC Authentication Server
MAC Auth Session Timeout Value : 1 secs
802.1x
Broadcast Key Refresh Rate
Session Key Refresh Rate
802.1x Session Timeout Value
Address Filtering
System Default : DENY addresses not found in filter table.
Filter Table
MAC Address
-----------------
00-70-50-cc-99-1a
00-70-50-cc-99-1b
=========================================================
DUAL OUTDOOR#

WDS Commands

The commands described in this section are used to configure the WIreless
Distribution System (WDS) forwarding table.
Command
wds channel
wds mac-address
wds enable
show wds
7-42
: REMOTE
: SUPPORTED
: 5 min
: 5 min
: 300 secs
: DENIED
Status
----------
DENIED
ALLOWED
Function
Selects the radio band to be used for bridge links
Configures MAC addresses of nodes in the wireless bridge
network
Enables WDS forwarding for specific wireless port IDs
Displays the current entries in the WDS forwarding table
Mode Page
GC 7-43
GC 7-43
GC 7-44
Exec 7-44