Vlan; Native-Vlanid - Hirschmann BAT54 Installation Manual

Note: Before enabling VLANs on the
LAN switch port to accept tagged VLAN packets with the
VLAN ID. Otherwise, connectivity to the
enable the VLAN feature.
The VLAN commands supported by the wireless bridge are listed below.
Command

vlan

native-vlanid

vlan
This command enables VLANs for all traffic. Use the no form to disable VLANs.
Syntax
vlan enable
no vlan
Default
Disabled
Command Mode
Global Configuration
Command Description
• Changing the VLAN status of the wireless bridge forces a system reboot.
• When VLANs are enabled, the wireless bridge tags frames received from
wireless interface with the configured native VLAN ID.
• Traffic entering the Ethernet port must be tagged with a VLAN ID that
matches the wireless bridge's native VLAN ID.
Example
DUAL OUTDOOR(config)#vlan enable
Reboot system now? <y/n>: y
Related Commands
native-vlanid (7-87)
native-vlanid
This command configures the native VLAN ID for the wireless bridge.
Syntax
native-vlanid <vlan-id>
vlan-id - Native VLAN ID. (Range: 1-64)
Default Setting
1
wireless bridge
Function
Enables a single VLAN for all traffic
Configures the native VLAN for the access point
VLAN Commands
, you must configure the connected
wireless bridge
wireless bridge
will be lost when you
7
's native
Mode Page
GC 7-87
GC 7-87
7-87