System Clock Commands; Sntp-Server Ip - Hirschmann BAT54 Installation Manual

7
Command Line Interface

System Clock Commands

These commands are used to configure SNTP and system clock settings on the
wireless bridge.
Command

sntp-server ip

sntp-server enable
sntp-server date-time
sntp-server
daylight-saving
sntp-server timezone
show sntp
sntp-server ip
This command sets the IP address of the servers to which SNTP time requests are
issued. Use the this command with no arguments to clear all time servers from the
current list.
Syntax
sntp-server ip <1 | 2> <ip>
• 1 - First time server.
• 2 - Second time server.
• ip - IP address of an time server (NTP or SNTP).
Default Setting
137.92.140.80
192.43.244.18
Command Mode
Global Configuration
Command Usage
When SNTP client mode is enabled using the sntp-server enable command,
the sntp-server ip command specifies the time servers from which the
wireless bridge polls for time updates. The wireless bridge will poll the time
servers in the order specified until a response is received.
Example
DUAL OUTDOOR(config)#sntp-server ip 10.1.0.19
DUAL OUTDOOR#
Related Commands
sntp-server enable (7-21)
show sntp (7-23)
7-20
Function
Specifies one or more time servers
Accepts time from the specified time servers
Manually sets the system date and time
Sets the start and end dates for daylight savings time
Sets the time zone for the wireless bridge's internal clock
Shows current SNTP configuration settings
Mode Page
GC 7-20
GC 7-21
GC 7-21
GC 7-22
GC 7-22
Exec 7-23