Table of Contents
Advertisement
7
Command Line Interface
Example
DUAL OUTDOOR(if-wireless a)#channel 36
DUAL OUTDOOR(if-wireless a)#
turbo
This command sets the wireless bridge to an enhanced mode (not regulated in IEEE
802.11a) that provides a higher data rate of up to 108 Mbps.
Default Setting
Disabled
Command Mode
Interface Configuration (Wireless - 802.11a)
Command Usage
• The normal 802.11a wireless operation mode provides connections up to
54 Mbps. Turbo Mode is an enhanced mode (not regulated in IEEE
802.11a) that provides a higher data rate of up to 108 Mbps. Enabling Turbo
Mode allows the wireless bridge to provide connections up to 108 Mbps.
• In normal mode, the wireless bridge provides a channel bandwidth of 20
MHz, and supports the maximum number of channels permitted by local
regulations (e.g., 11 channels for the United States). In Turbo Mode, the
channel bandwidth is increased to 40 MHz to support the increased data
rate. However, this reduces the number of channels supported (e.g., 5
channels for the United States).
Example
DUAL OUTDOOR(if-wireless a)#turbo
DUAL OUTDOOR(if-wireless a)#
beacon-interval
This command configures the rate at which beacon signals are transmitted from the
wireless bridge.
Syntax
beacon-interval <interval>
interval - The rate for transmitting beacon signals.
(Range: 20-1000 milliseconds)
Default Setting
100
Command Mode
Interface Configuration (Wireless)
7-72
Advertisement
Table of Contents
