Table of Contents
Advertisement
Interface). You can also display a list of valid keywords for a specific command. For
example, the command "show ?" displays a list of possible show commands:
Outdoor Bridge#show ?
authentication
bootfile
bridge
filters
hardware
history
interface
line
logging
memory-allocation
pppoe
radius
snmp
sntp
station
system
version
wds
DUAL OUTDOOR#showDUAL OUTDOOR#show ?
The command "show interface ?" will display the following information:
DUAL OUTDOOR#show interface ?
ethernet
Show Ethernet interface
wireless
Show wireless interface
<cr>
DUAL OUTDOOR#show interface
Partial Keyword Lookup
If you terminate a partial keyword with a question mark, alternatives that match the
initial letters are provided. (Remember not to leave a space between the command
and question mark.) For example "s?" shows all the keywords starting with "s."
DUAL OUTDOOR#show s?
snmp
sntp
DUAL OUTDOOR#show s
Negating the Effect of Commands
For many configuration commands you can enter the prefix keyword "no" to cancel
the effect of a command or reset the configuration to the default value. For example,
the logging command will log system messages to a host server. To disable
logging, specify the no logging command. This guide describes the negation effect
for all applicable commands.
Using Command History
The CLI maintains a history of commands that have been entered. You can scroll
back through the history of commands by pressing the up arrow key. Any command
displayed in the history list can be executed again, or first modified and then
executed.
Show Authentication parameters
Show bootfile name
Show bridge table
Show filters
Show hardware version
Display the session history
Show interface information
TTY line information
Show the logging buffers
Show memory allocation
Show PPPoE parameters
Show radius server
Show snmp statistics
Show sntp statistics
Show 802.11 station table
Show system information
Show system version
Show wds table
station
system
Entering Commands
7
7-3
Advertisement
Table of Contents
