Sntp-Server Daylight-Saving; Sntp-Server Timezone - Hirschmann BAT54 Installation Manual

7
Command Line Interface
Related Commands
sntp-server enable (7-21)

sntp-server daylight-saving

This command sets the start and end dates for daylight savings time. Use the no
form to disable daylight savings time.
Syntax
sntp-server daylight-saving
no sntp-server daylight-saving
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
The command sets the system clock back one hour during the specified
period.
Example
This sets daylight savings time to be used from July 1st to September 1st.
DUAL OUTDOOR(config)#sntp-server daylight-saving
Enter Daylight saving from which month<1-12>: 6
and which day<1-31>: 1
Enter Daylight saving end to which month<1-12>: 9
and which day<1-31>: 1
DUAL OUTDOOR(config)#

sntp-server timezone

This command sets the time zone for the wireless bridge's internal clock.
Syntax
sntp-server timezone <hours>
hours - Number of hours before/after UTC.
(Range: -12 to +12 hours)
Default Setting
None
Command Mode
Global Configuration
7-22