System Logging Commands; Logging On - Hirschmann BAT54 Installation Manual

7
Command Line Interface
Example
DUAL OUTDOOR#show version
Version v1.1.2.1B05
DUAL OUTDOOR#

System Logging Commands

These commands are used to configure system logging on the wireless bridge.
Command

logging on

logging host
logging console
logging level
logging facility-type
show logging
logging on
This command controls logging of error messages; i.e., sending debug or error
messages to memory. The no form disables the logging process.
Syntax
logging on
no logging on
Default Setting
None
Command Mode
Global Configuration
Command Usage
The logging process controls error messages saved to memory. You can use
the logging level command to control the type of error messages that are
stored in memory.
Example
DUAL OUTDOOR(config)#logging on
DUAL OUTDOOR(config)#
7-16
Function
Controls logging of error messages
Adds a syslog server host IP address that will receive logging
messages
Initiates logging of error messages to the console
Defines the minimum severity level for event logging
Sets the facility type for remote logging of syslog messages
Displays the state of logging
Mode Page
GC 7-16
GC 7-17
GC 7-17
GC 7-18
GC 7-18
Exec 7-19