Snmp Commands; Snmp-Server Community - Hirschmann BAT54 Installation Manual

7
Command Line Interface

SNMP Commands

Controls access to this wireless bridge from management stations using the Simple
Network Management Protocol (SNMP), as well as the hosts that will receive trap
messages.
Command
snmp-server community Sets up the community access string to permit access to
snmp-server contact
snmp-server enable
server
snmp-server host
snmp-server location
show snmp

snmp-server community

This command defines the community access string for the Simple Network
Management Protocol. Use the no form to remove the specified community string.
Syntax
snmp-server community string [ro | rw]
no snmp-server community string
• string - Community string that acts like a password and permits access to
the SNMP protocol. (Maximum length: 23 characters, case sensitive)
• ro - Specifies read-only access. Authorized management stations are only
able to retrieve MIB objects.
• rw - Specifies read/write access. Authorized management stations are able
to both retrieve and modify MIB objects.
Default Setting
• public - Read-only access. Authorized management stations are only able
to retrieve MIB objects.
• private - Read/write access. Authorized management stations are able to
both retrieve and modify MIB objects.
Command Mode
Global Configuration
Command Usage
If you enter a community string without the ro or rw option, the default is read
only.
Example
DUAL OUTDOOR(config)#snmp-server community alpha rw
DUAL OUTDOOR(config)#
7-24
Function
SNMP commands
Sets the system contact string
Enables SNMP service and traps
Specifies the recipient of an SNMP notification operation
Sets the system location string
Displays the status of SNMP communications
Mode Page
GC 7-24
GC 7-25
GC 7-25
GC 7-26
GC 7-27
Exec 7-27