Table of Contents
Advertisement
7
Command Line Interface
ssid
This command configures the service set identifier (SSID).
Syntax
ssid <string>
string - The name of a basic service set supported by the access point.
(Range: 1 - 32 characters)
Default Setting
DualBandOutdoor
Command Mode
Interface Configuration (Wireless)
Command Usage
Clients that want to connect to the wireless network via an access point must
set their SSIDs to the same as that of the access point.
Example
AP(if-wireless g)#ssid RD-AP#3
AP(if-wireless g)#
closed-system
This command closes access to clients without a pre-configured SSID. Use the no
form to disable this feature.
Syntax
closed-system
no closed-system
Default Setting
Disabled
Command Mode
Interface Configuration (Wireless)
Command Usage
When closed system is enabled, the access point will not include its SSID in
beacon messages. Nor will it respond to probe requests from clients that do
not include a fixed SSID.
Example
AP(if-wireless g)#closed-system
AP(if-wireless g)#
7-70
Advertisement
Table of Contents
