Ping - Hirschmann BAT54 Installation Manual

7
Command Line Interface
Example
This example shows how to return to the Exec mode from the Interface
Configuration mode, and then quit the CLI session:
DUAL OUTDOOR(if-ethernet)#exit
DUAL OUTDOOR#exit
CLI session with the wireless bridge is now closed
Username:

ping

This command sends ICMP echo request packets to another node on the network.
Syntax
ping <host_name | ip_address>
• host_name - Alias of the host.
• ip_address - IP address of the host.
Default Setting
None
Command Mode
Exec
Command Usage
• Use the ping command to see if another site on the network can be
reached.
• The following are some results of the ping command:
- Normal response - The normal response occurs in one to ten seconds,
depending on network traffic.
- Destination does not respond - If the host does not respond, a "timeout"
appears in ten seconds.
- Destination unreachable - The gateway for this destination indicates that
the destination is unreachable.
- Network or host unreachable - The gateway found no corresponding
entry in the route table.
• Press <Esc> to stop pinging.
Example
DUAL OUTDOOR#ping 10.1.0.19
192.168.1.19 is alive
DUAL OUTDOOR#
7-8