Snmp-Server Contact; Snmp-Server Enable Server - Hirschmann BAT54 Installation Manual

snmp-server contact

This command sets the system contact string. Use the no form to remove the
system contact information.
Syntax
snmp-server contact string
no snmp-server contact
string - String that describes the system contact. (Maximum length: 255
characters)
Default Setting
Contact
Command Mode
Global Configuration
Example
DUAL OUTDOOR(config)#snmp-server contact Paul
DUAL OUTDOOR(config)#
Related Commands
snmp-server location (7-27)

snmp-server enable server

This command enables SNMP management access and also enables this device to
send SNMP traps (i.e., notifications). Use the no form to disable SNMP service and
trap messages.
Syntax
snmp-server enable server
no snmp-server enable server
Default Setting
Enabled
Command Mode
Global Configuration
Command Usage
• This command enables both authentication failure notifications and
link-up-down notifications.
• The snmp-server host command specifies the host device that will receive
SNMP notifications.
7
SNMP Commands
7-25