Snmp-Server Host - Hirschmann BAT54 Installation Manual

7
Command Line Interface
Example
DUAL OUTDOOR(config)#snmp-server enable server
DUAL OUTDOOR(config)#
Related Commands

snmp-server host (7-26)

snmp-server host
This command specifies the recipient of an SNMP notification. Use the no form to
remove the specified host.
Syntax
snmp-server host <host_ip_address | host_name> <community-string>
no snmp-server host
• host_ip_address - IP of the host (the targeted recipient).
• host_name - Name of the host. (Range: 1-20 characters)
• community-string - Password-like community string sent with the
notification operation. Although you can set this string using the
snmp-server host command by itself, we recommend that you define this
string using the snmp-server community command prior to using the
snmp-server host command. (Maximum length: 23 characters)
Default Setting
Host Address: None
Community String: public
Command Mode
Global Configuration
Command Usage
The snmp-server host command is used in conjunction with the
snmp-server enable server command to enable SNMP notifications.
Example
DUAL OUTDOOR(config)#snmp-server host 10.1.19.23 batman
DUAL OUTDOOR(config)#
Related Commands
snmp-server enable server (7-25)
7-26