Bridge - Hirschmann BAT54 Installation Manual

Port Number (Master bridge only) – The wireless port identifier.
MAC Address – The physical layer address of the wireless bridge unit at the other
end of the wireless link. (12 hexadecimal digits in the form "xx:xx:xx:xx:xx:xx")
Port Status – Enables or disables the wireless bridge link.
The wireless MAC address for each bridge unit is printed on the label on the
Note:
back of the unit.
CLI Commands for WDS – The following example shows how to configure the MAC
address of the wireless bridge at the opposite end of a point-to-point link, and then
enable forwarding on the link.
DUAL OUTDOOR(config)#wds mac-address 1 00-12-34-56-78-9a
DUAL OUTDOOR(config)#wds enable
DUAL OUTDOOR(config)#exit
DUAL OUTDOOR#show wds
Outdoor_Mode
==================================================
Port ID |
==================================================
01 |
==================================================
DUAL OUTDOOR#

Bridge

The wireless bridge can store the MAC addresses for all known devices in the
connected networks. All the addresses are learned by monitoring traffic received by
the wireless bridge and are stored in a dynamic MAC address table. This information
is then used to forward traffic directly between the Ethernet port and the
corresponding wireless interface.
: SLAVE
Status | Mac-Address
ENABLE | 00-12-34-56-78-9A
Advanced Configuration
6
7-43
7-44
7-44
6-33