Filtering Commands; Filter Local-Bridge - Hirschmann BAT54 Installation Manual

Example
DUAL OUTDOOR#show bridge
Bridge
=================================================
Media Type | Age Time(sec)|
=================================================
EtherNet | 300
WLAN_A | 1000
==================================================
Bridge Id
Root Bridge Id
Root Path Cost
Root Port Id
Bridge Status
Bridge Priority
Bridge Hello Time
Bridge Maximum Age
Bridge Forward Delay: 15 Seconds
============================= Port Summary =============================
Id| Priority | Path Cost |
0 128
DUAL OUTDOOR#

Filtering Commands

The commands described in this section are used to control access to the
management interface from the wireless interface and filter traffic using specific
Ethernet protocol types.
Command

filter local-bridge

filter ap-manage
filter ethernet-type enable Checks the Ethernet type for all incoming and outgoing
filter ethernet-type
protocol
show filter
filter local-bridge
This command disables communication between wireless clients. Use the no form
to disable this filtering.
Syntax
filter local-bridge
no filter local-bridge
Information
|
|
: 32768.037fbef192
: 32768.01f47483e2
: 25
: 0
: Enabled
: 32768
: 2 Seconds
: 20 Seconds
Fast Forward
25 Enable
Function
Disables communication between wireless clients
Prevents access to the management interface over the
wireless bridge link
Ethernet packets against the protocol filtering table
Sets a filter for a specific Ethernet type
Shows the filter configuration
Filtering Commands
| Status |
Enabled Forwarding
7
State |
Mode Page
GC 7-53
GC 7-54
GC 7-54
GC 7-55
Exec 7-56
7-53