Show Pppoe; Ethernet Interface Commands - Hirschmann BAT54 Installation Manual

show pppoe

This command shows information about the PPPoE configuration.
Command Mode
Privileged Exec
Example
DUAL OUTDOOR#show pppoe
PPPoE Information
======================================================
State
Username
Service Name
IP Allocation Mode
DNS Negotiation
Local IP
Echo Interval
Echo Failure
======================================================
DUAL OUTDOOR#

Ethernet Interface Commands

The commands described in this section configure connection parameters for the
Ethernet interface.
Command
interface ethernet
dns primary-server
dns secondary-server
ip address
ip dhcp
shutdown
show interface ethernet
: Link up
: mike
: classA
: Static
: Enabled
: 10.7.1.200
: 30
: 5
Function
Enters Ethernet interface configuration mode
Specifies the primary name server
Specifies the secondary name server
Sets the IP address for the Ethernet interface
Submits a DHCP request for an IP address
Disables the Ethernet interface
Shows the status for the Ethernet interface
Ethernet Interface Commands
Mode
GC
IC-E
IC-E
IC-E
IC-E
IC-E
Exec
7
Page
7-64
7-64
7-64
7-65
7-66
7-66
7-67
7-63