Wireless Distribution System (Wds) - Hirschmann BAT54 Installation Manual

CLI Commands for the System Clock – The following example shows how to
manually set the system time when SNTP server support is disabled on the wireless
bridge.
DUAL OUTDOOR(config)#no sntp-server enable
DUAL OUTDOOR(config)#sntp-server date-time
Enter Year<1970-2100>: 2003
Enter Month<1-12>: 10
Enter Day<1-31>: 10
Enter Hour<0-23>: 18
Enter Min<0-59>: 35
DUAL OUTDOOR(config)#

Wireless Distribution System (WDS)

The IEEE 802.11 standard defines a WIreless Distribution System (WDS) for
connections between wireless bridges. The access point uses WDS to forward
traffic on bridge links between units. When using WDS, only wireless bridge units
can associate to each other using the bridge band. A wireless client cannot
associate with the access point on the wireless bridge band.
To set up a wireless bridge link, you must configure the WDS forwarding table by
specifying the wireless MAC address of the bridge to which you want to forward
traffic. For a Slave bridge unit, you need to specify the MAC address of the wireless
bridge unit at the opposite end of the link. For a Master bridge unit, you need to
specify the MAC addresses of all the Slave bridge units in the network.
Advanced Configuration
6
7-21
7-21
6-31