Administration - Hirschmann BAT54 Installation Manual

Administration

Changing the Password
Management access to the web and CLI interface on the wireless bridge is
controlled through a single user name and password. You can also gain additional
access security by using control filters (see "Filter Control" on page 6-18).
To protect access to the management interface, you need to configure an
Administrator's user name and password as soon as possible. If the user name and
password are not configured, then anyone having access to the wireless bridge may
be able to compromise wireless bridge and network security.
Pressing the Reset button on the back of the wireless bridge for more than
Note:
five seconds resets the user name and password to the factory defaults. For
this reason, we recommend that you protect the wireless bridge from
physical access by unauthorized persons.
Username – The name of the user. The default name is "admin." (Length: 3-16
characters, case sensitive.)
New Password – The password for management access. (Length: 3-16 characters,
case sensitive)
Confirm New Password – Enter the password again for verification.
CLI Commands for the User Name and Password – Use the username and
password commands from the CLI configuration mode.
DUAL OUTDOOR(config)#username bob
DUAL OUTDOOR(config)#password spiderman
DUAL OUTDOOR#
Advanced Configuration
6
7-13
7-13
6-23