Bridge Stp-Bridge Priority - Hirschmann BAT54 Installation Manual

Default Setting
20 seconds
Command Mode
Global Configuration
Command Usage
This command sets the maximum time (in seconds) a device can wait without
receiving a configuration message before attempting to reconfigure. All device
ports (except for designated ports) should receive configuration messages at
regular intervals. Any port that ages out STP information (provided in the last
configuration message) becomes the designated port for the attached LAN. If
it is a root port, a new root port is selected from among the device ports
attached to the network.
Example
DUAL OUTDOOR(config)#bridge stp-bridge max-age 40
DUAL OUTDOOR(config)#

bridge stp-bridge priority

Use this command to configure the spanning tree priority globally for the wireless
bridge. Use the no form to restore the default.
Syntax
bridge stp-bridge priority priority
no bridge stp-bridge priority
priority - Priority of the bridge. (Range: 0 - 65535)
Default Setting
32768
Command Mode
Global Configuration
Command Usage
Bridge priority is used in selecting the root device, root port, and designated
port. The device with the highest priority becomes the STP root device.
However, if all devices have the same priority, the device with the lowest MAC
address will then become the root device.
Example
DUAL OUTDOOR(config)#bridge stp-bridge priority 40000
DUAL OUTDOOR(config)#
7
Bridge Commands
7-49