Show Filters; Pppoe Commands - Hirschmann BAT54 Installation Manual

7
Command Line Interface

show filters

This command shows the filter options and protocol entries in the filter table.
Command Mode
Exec
Example
DUAL OUTDOOR#show filters
Protocol Filter Information
=========================================================
AP Management
Ethernet Type Filter :ENABLED
Enabled Protocol Filters
---------------------------------------------------------
Protocol: ARP
=========================================================
DUAL OUTDOOR#

PPPoE Commands

The commands described in this section configure PPPoE management tunnel
connection parameters for the Ethernet port.
Command
ip pppoe
pppoe ip allocation mode
pppoe ipcp dns
pppoe lcp echo-interval
pppoe lcp echo-failure
pppoe local ip
pppoe remote ip
pppoe username
pppoe password
pppoe service-name
pppoe restart
show pppoe
7-56
:ENABLED
Function
Enables PPPoE on the Ethernet interface
Specifies how IP addresses for the PPPoE tunnel are
configured on the interface
Negotiates DNS for the PPPoE tunnel
Sets LCP echo interval for the PPPoE tunnel
Sets LCP echo timeout for the PPPoE tunnel
Sets local IP address for the PPPoE tunnel
Sets remote IP address for the PPPoE tunnel
Sets the user name for the PPPoE tunnel
Sets the password for the PPPoE tunnel
Sets the service name for the PPPoE tunnel
Restarts the PPPoE connection with updated
parameters
Shows information about the PPPoE configuration
ISO: 0x0806
Mode Page
IC-E 7-57
IC-E 7-57
IC-E 7-58
IC-E 7-58
IC-E 7-59
IC-E 7-60
IC-E 7-60
IC-E 7-61
IC-E 7-61
IC-E 7-62
IC-E 7-62
PE 7-63