Address Filter Entry; Address Filter Delete - Hirschmann BAT54 Installation Manual

7
Command Line Interface

address filter entry

This command enters a MAC address in the filter table.
Syntax
address filter entry <mac-address> <allowed | denied>
• mac-address - Physical address of client. (Enter six pairs of hexadecimal
digits separated by hyphens; e.g., 00-90-D1-12-AB-89.)
• allowed - Entry is allowed access.
• denied - Entry is denied access.
Default
None
Command Mode
Global Configuration
Command Mode
• The access point supports up to 1024 MAC addresses.
• An entry in the address table may be allowed or denied access depending
on the global setting configured for the address entry default command.
Example
(config)#address filter entry 00-70-50-cc-99-1a
DUAL OUTDOOR
allowed
(config)#
DUAL OUTDOOR
Related Commands
address filter default (7-39)
show authentication (7-42)

address filter delete

This command deletes a MAC address from the filter table.
Syntax
address filter delete <mac-address>
mac-address - Physical address of client. (Enter six pairs of hexadecimal
digits separated by hyphens.)
Default
None
Command Mode
Global Configuration
7-40