Pppoe Ipcp Dns; Pppoe Lcp Echo-Interval - Hirschmann BAT54 Installation Manual

7
Command Line Interface
Example
DUAL OUTDOOR#(if-ethernet)#pppoe ip allocation mode static
DUAL OUTDOOR#
Related Commands
pppoe local ip (7-60)
pppoe remote ip (7-60)

pppoe ipcp dns

This command requests allocation of IP addresses for Dynamic Naming System
(DNS) servers from the device at the remote end of the PPPoE tunnel.
Syntax
pppoe ipcp dns
no pppoe ipcp dns
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet)
Command Usage
DNS servers are used to translate host computer names into IP addresses.
PPPoE clients can request a primary and secondary DNS server from the
network connection device at the remote end of the PPPoE tunnel. This
request is passed to the remote end during the IP Control Protocol (IPCP)
negotiation phase during session initialization.
Example
DUAL OUTDOOR#(if-ethernet)#pppoe ipcp dns
DUAL OUTDOOR#

pppoe lcp echo-interval

This command sets the Link Control Protocol (LCP) echo interval for the PPPoE
tunnel.
Syntax
pppoe lcp echo-interval <interval>
interval - The interval between sending echo requests.
(Range: 1-60 seconds)
Default Setting
10
Command Mode
Interface Configuration (Ethernet)
7-58