Snmp - Hirschmann BAT54 Installation Manual

6
System Configuration
CLI Commands for VLAN Support – From the global configuration mode use the
native-vlanid command to set the default VLAN ID for the Ethernet interface, then
enable VLANs using the vlan enable command. When you change the access
point's VLAN support setting, you must reboot the access point to implement the
change. To view the current VLAN settings, use the show system command.
DUAL OUTDOOR(config)#native-vlanid 3
DUAL OUTDOOR(config)#vlan enable
Reboot system now? <y/n>: y
CLI Commands for Bridge Filtering – Use the
management access from wireless clients. To configure Ethernet protocol filtering,
use the
filter ethernet-type enable
ethernet-type protocol
display the current settings, use the
DUAL OUTDOOR(config)#filter ap-manage
DUAL OUTDOOR(config)#filter ethernet-type enable
DUAL OUTDOOR(config)#filter ethernet-type protocol ARP
DUAL OUTDOOR(config)#exit
DUAL OUTDOOR#show filters
Protocol Filter Information
=========================================================
AP Management
Ethernet Type Filter :ENABLED
Enabled Protocol Filters
---------------------------------------------------------
Protocol: ARP
=========================================================
DUAL OUTDOOR#

SNMP

You can use a network management application to manage the wireless bridge via
the Simple Network Management Protocol (SNMP) from a management station. To
implement SNMP management, the wireless bridge must have an IP address and
subnet mask, configured either manually or dynamically. Once an IP address has
been configured, appropriate SNMP communities and trap receivers should be
configured.
Community names are used to control management access to SNMP stations, as
well as to authorize SNMP stations to receive trap messages from the wireless
bridge. To communicate with the wireless bridge, a management station must first
submit a valid community name for authentication. You therefore need to assign
community names to specified users or user groups and set the access level.
6-20
command to enable filtering and the
command to define the protocols that you want to filter. To
show filters
:ENABLED
command to restrict
filter ap-manage
command from the Exec mode.
ISO: 0x0806
7-87
7-87
filter
7-54
7-54
7-55
7-56